Escape 4WD V6-3.0L (2008)
3. Align the OCS bladder to the seat cushion pan.
4. Install the 2 pin-type retainers to the OCS bladder and seat cushion pan.
5. NOTE: Make sure the pressure sensor hose is not kinked during installation.
Install the pressure sensor onto the seat cushion pan bracket, making sure the retaining tab is completely engaged.
-
When installed correctly, an audible click will be heard and the pressure sensor will not be able to be removed from its bracket without
disengaging the retaining tab.
6. Slide the OCS ECU into the seat cushion pan bracket and install the rivets.
-
The OCS ECU must be correctly positioned and securely fastened in place. Failure to do so can set a DTC in the RCM.
7. Position the foam pad to the seat cushion pan.
8. CAUTION: Inspect the seat cushion pad and seat cushion trim cover for any foreign material, before installing the seat cushion trim
cover to the seat cushion pad. If any foreign material is found, remove it. Failure to follow these instructions may result in incorrect
operation of the OCS system and may cause system failure.
Install the seat cushion trim cover to the seat cushion foam pad and attach the J-clips.
9. CAUTION: While positioning the seat cushion pan and occupant classification sensor (OCS) assembly, be careful not to damage any of
the components. Failure to follow these instructions may result in incorrect operation of the OCS system and may cause system failure.
Position the seat cushion and pan assembly to the seat track.
-
To aid in installation, recline the seat.
10. Install the 4 seat cushion bolts retaining the seat cushion to the seat track.
-
Tighten to 15 Nm (11 lb-ft).
11. Connect the electrical connectors and wiring clips.
1
Connect the OCS ECU electrical connector.
2
Connect the pressure sensor electrical connector.
3
Install the 2 wiring clips on the wiring harness to the seat cushion pan.
4
If equipped with heated seats, connect the heated seat relay electrical connector, install the wiring clip on the wiring harness to the seat cushion
pan, and connect the 2 seat cushion element electrical connectors.
