Escape 4WD V6-3.0L (2008)
4. Attach the seat cushion trim cover J-clips to the seat cushion pan.
5. CAUTION: While positioning the seat cushion pan and occupant classification sensor (OCS) assembly, be careful not to damage any of
the components. Failure to follow these instructions may result in component damage and/or system failure.
Position the seat cushion and pan assembly to the seat track.
-
To aid in installation, recline the seat.
6. Install the 4 seat cushion bolts retaining the seat cushion to the seat track.
-
Tighten to 15 Nm (11 lb-ft).
7. NOTE:
-
Do not tie strap any wiring to the OCS bladder and pressure sensor hose.
-
The seat wiring harness will be reused.
Connect the electrical connector(s) and wiring clips.
1
Connect the seat wire harness OCS electrical connector to the service part OCS electrical connector.
2
Install the 2 wiring clips on the wiring harness to the cushion pan.
3
If equipped with heated seats, connect the heated seat module electrical connector, install the wiring clip on the wiring harness to the cushion
pan, and connect the 2 cushion element electrical connectors.
4
Tie strap the unused seat wire harness pressure sensor electrical connector safely aside.
5
Tie strap all loose wire harnesses and electrical connectors safely aside.
