Escape 4WD V6-3.0L (2008)
6. Position the generator B+ protective cover aside and remove the generator B+ terminal nut.
-
To install, tighten to 12 Nm (9 lb-ft).
7. Remove the 3 A/C compressor bolts. Use a tie-strap and position A/C compressor aside.
-
To install, tighten to 25 Nm (18 lb-ft).
8. Loosen the 2 generator nuts.
-
To install, tighten to 47 Nm (35 lb-ft).
9. Remove the 2 lower generator studs.
-
To install, tighten to 7 Nm (62 lb-in).
10. Remove the upper generator bolt and the generator.
-
To install, tighten to 47 Nm (35 lb-ft).
11. To install, reverse the removal procedure.
-
Tighten the upper generator bolt with vehicle on the ground.
