Escape 4WD V6-3.0L (2008)
retainers make an audible click when attaching to the bumper cover.
^
Hand-Tighten the two lower grille speed nuts until the speed nuts are snug.
^
Hand-tighten the two lower inside grille bolts until the bolts are snug.
^ Tighten the two upper grille bolts to 8 Nm (71 lb-in).
MARINER
6. Install the front bumper cover. For additional information refer to the WSM Section 501-19.
SERVICE PROCEDURE 2 - GROMMET NOT PRESENT AND TRANSMISSION
FLUID COOLER LEAKING
ESCAPE AND MARINER
1. NOTE: On Escape it will be necessary to remove the remaining front bumper cover for the transmission fluid cooler replacement.
If during the inspection there WAS a fluid leak replace the transmission fluid cooler. For additional information refer to the WSM Section 307-02A
ESCAPE
2. Install the radiator grille onto the bumper cover. See Figure 3.
^
Attach the three lower grille retainers to the front bumper cover by pushing the grille into the bumper cover Make sure that all three grille
retainers make an audible click when attaching to the bumper cover
^
Hand-tighten the two lower grille speed nuts until the speed nuts are snug
^
Hand-tighten the two lower inside grille bolts until the bolts are snug
3. Install the front bumper cover. For additional information refer to the WSM Section 501-19.
^
Tighten the two upper grille bolts to 8 Nm (71 lb-in).
MARINER
4. Install the front bumper cover. For additional information, refer to the WSM, Section 501-19.
