Escape 4WD V6-3.0L VIN 1 (2005)
4. Install the bolts, SEE TSB 06-3-5.
^
Tighten in the sequence shown to 10 Nm (89 inch lbs.).
5. NOTE: Lubricate the camshaft oil seal with clean engine oil.
Using the special tools, install the camshaft oil seal.
6. CAUTION: The OEM pulley is pressed on 4.74 mm (0.18 inch) past flush of the end of the camshaft. The service pulley is pressed on flush to
the end of the camshaft.
Using the special tool, install a new service coolant pump pulley.
7. Install the timing drive components.
8. Install the coolant pump belt.
