Escape 4WD V6-3.0L VIN 1 (2005)
Idler Pulley: Service and Repair
Accessory Drive Belt Idler Pulley
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the bolts and the RH splash shield.
^
To install, tighten to 7 Nm (62 inch lbs.).
3. Using a suitable belt tensioner release tool, rotate the accessory drive belt tensioner counterclockwise and remove the accessory drive belt.
4. Remove the bolt and the accessory drive belt idler pulley.
^
To install, tighten to 25 Nm (18 ft. lbs.).
5. NOTE: Refer to the illustration for correct drive belt routing.
To install, reverse the removal procedure.
