Escape 4WD V6-3.0L VIN 1 (2005)
1. Position the lower intake manifold and install the bolts.
^
Tighten in the sequence shown to 10 Nm (89 inch lbs.).
2. Connect the fuel injector electrical connectors.
3. Connect the fuel rail pressure and temperature sensor electrical connector and vacuum tube.
4. NOTE: Make sure the collar on the fuel tube is inserted fully into the quick release coupling before the locking tang is locked.
NOTE: Apply clean engine oil to the end of the tube before inserting a tube into the connector.
Connect the fuel tube quick connect coupling.
^
Connect the quick lock coupling to the tube.
^
Press the quick connect coupling locking tangs into position.
^
Pull on the fitting to make sure it is fully engaged.
5. Install the upper intake manifold.
6. Connect the battery ground cable.
