Escape 4WD V6-3.0L VIN 1 (2005)
finds the assemblies show no damage and operate correctly. Safety belt assemblies not in use during a collision should also be inspected and new
assemblies installed if either damage or incorrect operation is noted.
The Automatic Locking Retractor (ALR) feature of the safety belt retractor must be checked by a qualified technician to verify that the ALR
feature for a child seat is functioning properly, in addition to other checks for proper safety belt system function. A belt and retractor assembly
must be replaced if the safety belt assembly's "automatic locking retractor" feature or any other safety belt function is not operating properly when
inspected according to the functional inspection procedures. Failure to replace the belt and retractor assembly could increase the risk of injury in
collisions.
-
To reduce the risk of personal injury, do not use any memory saver devices.
NOTE:
-
The air bag warning lamp illuminates when the RCM fuse is removed and the ignition switch is ON. This is normal operation and does not indicate
a supplemental restraint system (SRS) fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
-
Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and carry out the diagnostic
procedure again.
-
The passenger side safety belt retractor is shown, the driver side is similar.
All front retractors
1. Remove the B-pillar trim panel.
Front passenger retractor
2. Depower the SRS.
3. Disconnect the belt tension sensor electrical connector.
All front retractors
4. Remove the safety belt retractor anchor bolt.
-
To install, tighten to 47 Nm (35 lb-ft).
5. Remove the safety belt retractor upper bolt.
-
To install, tighten to 9 Nm (80 lb-in).
6. Remove the safety belt retractor lower bolt and the safety belt retractor.
-
To install, tighten to 47 Nm (35 lb-ft).
7. To install, reverse the removal procedure.
Front passenger retractor
8. Repower the SRS.
All front retractors
9. Check the active restraint system for correct operation.
-
Make sure that after the rear safety belt retractor is installed, the retractor is not in the automatic locking retractor (ALR) mode.
