Escape 4WD V6-3.0L VIN 1 (2005)
Impact Sensor: Description and Operation
SENSORS
WARNING:
-
The restraints control module (RCM) orientation is critical for correct system operation. If a vehicle equipped with an air bag
supplemental restraint system (SRS) has been involved in a collision in which the center tunnel area has been damaged, inspect the
mounting and bracket for deformation. If damaged, a new RCM must be installed whether or not the air bags have deployed. In addition,
make sure the area of the RCM mounting is restored to its original condition.
-
Vehicle sensor orientation is critical for correct system operation. If a vehicle equipped with an air bag supplemental restraint system
(SRS) is involved in a collision, inspect the sensor mounting bracket and wiring pigtail for deformation. Replace and correctly position
the sensor or any other damaged supplemental restraint system (SRS) components whether or not the air bag is deployed.
For these vehicles, the SRS uses up to 5 satellite sensors in addition to the RCM. The RCM is mounted to the center tunnel beneath the console. All
vehicles will have a front impact severity sensor and it is located in the front-center of the vehicle, mounted on the radiator support bracket. If the vehicle
is equipped with safety canopies, there are 4 additional side impact sensors. The 4 additional sensors are located at the base of each B-pillar and mounted
on the C-pillar. The LH and RH C-pillar mounted side impact sensors are interchangeable. Mounting orientation is critical for correct operation of all
impact and rollover sensors.
