Escape 4WD V6-3.0L VIN 1 (2005)
Removal and Installation
CAUTION: While repairing the power steering system, care should be taken to prevent the entry of contaminants or premature failure of the power
steering components can result.
1. Drain the power steering fluid into a suitable drain pan.
2. Rotate the accessory drive belt tensioner counterclockwise and position the accessory drive belt aside.
3. Release the clamp and remove the power steering fluid suction hose from the power steering pump.
4. Disconnect the power steering pressure line fitting nut from the power steering pump.
^
To install, tighten to 73 Nm (54 ft. lbs.).
5. Remove the 3 power steering pump bolts.
^
To install, tighten to 25 Nm (18 ft. lbs.).
6. CAUTION: Do not let the flow control valve fall out of the power steering pump.
Remove the power steering pump.
7. To install, reverse the removal procedure.
8. Fill the power steering system.
