Escape 4WD V6-3.0L VIN 1 (2005)
Stabilizer Bushing: Service and Repair
Stabilizer Bar Bushing
Removal and Installation
CAUTION: When installing the stabilizer bar bushings, make sure the bushings are correctly oriented with the bushing flanges in the up position and
the bushing split pointing to the rear of the vehicle.
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the 2 bolts and the stabilizer bar bushing bracket.
^
To install, tighten to 70 Nm (52 ft. lbs.).
3. NOTE: Inspect the stabilizer bar bushing for wear. If necessary, install a new part.
Remove the stabilizer bar bushing.
4. To install, reverse the removal procedure.
