Escape 4WD V6-3.0L VIN 1 (2005)
2. Disconnect the transmission fluid cooler tube clamps and disconnect the rubber hoses from the auxiliary cooler.
3. Disconnect the upper fluid cooler rubber hose from the radiator.
4. Disconnect the lower fluid cooler rubber hose from the radiator.
5. Disconnect and remove the front cooler tube from the transaxle case.
^
To install, tighten to 25 Nm (18 ft. lbs.).
6. Disconnect and remove the rear cooler tube from the transaxle case.
^
To install, tighten to 25 Nm (18 ft. lbs.).
