Escape 4WD V6-3.0L VIN 1 (2005)
3. Check the diaphragm spring fingers for discoloration, scoring, bent or broken segments and spring ends that are higher or lower than the rest.
4. WARNING: The clutch disc and clutch pressure plate are heavy and may fall if not held when the bolts are removed. Failure to follow
these instructions may result in personal injury.
CAUTION: Loosen the bolts evenly to prevent pressure plate damage.
Remove the bolts, clutch pressure plate and clutch disc.
5. CAUTION: Do not use cleaners with a petroleum base and do not immerse the clutch pressure plate in solvent.
Using a suitable commercial alcohol based solvent, clean the clutch pressure plate.
6. Inspect the clutch pressure plate surface for burn marks, scores, flatness or ridges.
7. CAUTION: If the clutch disc is saturated with oil, inspect the rear engine crankshaft seal for leakage. If leakage is found, install a new seal prior
to clutch disc installation.
NOTE: Use an emery cloth to remove minor imperfections in the clutch disc lining surface.
NOTE: Install a new clutch disc if any of the following conditions are present.
Inspect the clutch disc for:
^
oil or grease saturation
^
worn or loose facings
^
warpage or loose rivets at the hub
^
wear or rust on the splines
8. Check the clutch disc runout and wear.
Installation
1. Using the special tool, position the clutch disc on the flywheel.
