Escape 4WD V6-3.0L VIN 1 (2005)
Axle Shaft Assembly: Description and Operation
Rear Drive Halfshafts
Rear Drive Halfshafts
CAUTION: An inspection of the outer and inner boots is necessary so that if damage or grease leakage is evident, installation of a new halfshaft can
take place immediately. Continued operation with damage or grease leakage will result in CV joint wear and noise due to contamination and loss of
the CV joint grease.
NOTE: Handle all halfshaft components carefully during removal and installation procedures.
^
The inner and outer Constant Velocity (CV) joints connect to a splined shaft. A circlip stopper holds the cross groove inner race assembly (inner
CV joint) together.
^
The RH and LH halfshafts are the same length.
^
An axle circlip retains the splined inner CV joint to the differential side gear. Install a new axle circlip each time the halfshaft is removed from the
vehicle.
^
A rear axle wheel hub nut secures the side shaft assembly (interconnecting shaft and outer CV joint) to the rear hub. Install a new rear axle wheel
hub nut each time the halfshaft is removed from the vehicle.
