Escape 4WD V6-3.0L VIN 1 (2005)
Rear Door Window Regulator: Service and Repair
REAR DOOR WINDOW REGULATOR
Removal and Installation
1. Remove the rear door trim panel.
2. Remove the screw and the rear door trim panel bracket.
3. Position the watershield aside.
4. Connect the window control switch electrical connector.
5. Using the window control switch, lower the rear door window glass to gain access to the rear door window glass screws.
6. Disconnect the window control switch electrical connector.
7. Remove the 2 rear door window glass screws.
-
To install, tighten to 5 Nm (44 lb-in).
8. Support the rear door window glass in the full up position.
9. Disconnect the rear door window motor electrical connector.
10. Remove the 3 rear door window regulator and motor bolts.
-
To install, tighten to 6 Nm (53 lb-in).
11. Remove the 2 nuts and the rear door window regulator and motor.
-
To install, tighten to 6 Nm (53 lb-in).
12. To install, reverse the removal procedure.
