Escape AWD V6-3.0L VIN 1 (2004)
air bag to floor connector.
-
After diagnosing/repairing a seat system the restraint system diagnostic tool must be removed before operating the vehicle.
-
A repair is made by installing a new part only. If a new part is installed and the new part does not correct the condition, install the original part and
carry out the diagnostic procedure again.
-
If a side air bag deployment took place, a new seatback pad, trim cover, and side air bag module must be installed. A new seatback frame should
be installed if necessary.
-
Manual seat track shown, power seat track similar.
All vehicles
1. Position the front seats forward.
2. Disconnect the battery ground cable and wait at least one minute.
Vehicles with side air bag
3. Disconnect the driver side air bag module electrical connector.
4. Connect the special tool to the driver side air bag module body harness electrical connector.
All vehicles
5. Disconnect the driver safety belt pretensioner electrical connector.
