Escape AWD V6-3.0L VIN 1 (2004)
Condenser HVAC: Service and Repair
CONDENSER CORE
REMOVAL
NOTE:
-
Installation of a new suction accumulator is not necessary when repairing the air conditioning system except when there is physical evidence of
system contamination from a failed A/C compressor or damage to the suction accumulator.
-
If an A/C condenser core leak is suspected, the A/C condenser core must be leak tested before it is removed from the vehicle.
1. Recover the refrigerant.
2. Remove the front bumper cover.
3. CAUTION: Plug all ports to prevent contamination from dirt or moisture.
Remove the nuts from the two condenser core air conditioning line (peanut) fittings.
4. Remove the screws and the A/C condenser core brackets.
5. NOTE: When removing the A/C condenser core, disconnect the two air conditioning line (peanut) fittings from the A/C condenser core.
Remove the A/C condenser core.
INSTALLATION
1. To install, reverse the removal procedure.
-
Lubricate the new A/C condenser core with the correct amount of PAG Compressor Oil YN-12-C or equivalent meeting Ford specification
WSH-M1C231-B.
-
Lubricate the O-ring seals with PAG Compressor Oil YN-12-C or equivalent meeting Ford specification WSH-M1C231-B.
