Removal and Installation of Vacuum Brake Booster - Escort L4-110 18L DOHC (1994)
Vacuum Brake Booster: Service and Repair
Removal and Installation
1. Pump brake pedal several times to exhaust any vacuum in the booster.
2. Remove master cylinder from vehicle.
3. Disconnect rubber hose connecting intake manifold to power brake unit.
4. Remove spring clip in brake pedal clevis pin.
5. Remove brake pedal clevis pin, then brake pedal pushrod from brake pedal.
6. Remove power brake unit attaching nuts, then power brake unit from vehicle.
7. Reverse procedure to install, noting the following:
a. Ensure proper clearance between pushrod and master cylinder exists.
b. Torque booster to dash panel retaining nuts to 14-19 ft lb.
c. Torque master cylinder retaining nuts to 8-12 ft lb.
