ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Door Latch and Solenoid Assembly Service - Revision|Page 5955 > < Door Latch and Solenoid Assembly Service - Revision
Page 1
background image

Trunk / Liftgate Solenoid: Technical Service Bulletins
Door Latch and Solenoid Assembly Service - Revision

SHOP MANUAL-1989-PAGE 44-10-9A-NEW REMOVAL AND INSTALLATION PROCEDURES FOR LUGGAGE COMPARTMENT DOOR
LATCH ASSEMBLY (ELECTRICAL ONLY) AND SOLENOID ASSEMBLY
Article No. 89-18A-4
FORD:

1989 ESCORT

ISSUE:

The Removal and Installation procedures on the Luggage Compartment Door Latch Assembly (Electrical Only) and Solenoid Assembly for
Models 58 and 61 was not published in the 1989 Tempo/Topaz, Escort Shop Manual.

ACTION:

Refer to the page following this TSB article for the Removal and Installation procedures.

OTHER APPLICABLE ARTICLES: None
WARRANTY STATUS: INFORMATION ONLY
OASIS CODES:

2800

1989

44-10-9A

Luggage, Glove Compartment Door, Hinge, Latch, Lock and Weatherstrip

44-10-9A

REMOVAL AND INSTALLATION (Continued)

Lock Cylinder-Hatchback-Electrical Escort Removal and Installation
1.

Remove two (2) nuts retaining the solenoid assembly to lower back panel (inner) gusset.

2.

Disengage solenoid cable from the latch assembly and disconnect the solenoid wire from the wiring assembly to remove the solenoid assembly as
shown.

3.

To install, reverse Steps 1 and 2.

Door Latch and Solenoid Assembly Service - Revision|Page 5955 > < Door Latch and Solenoid Assembly Service - Revision