ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Hose/Line HVAC > < Heater Core - Core Leak Test Procedure|Page 5550
Page 1
background image

Heater Core: Service and Repair

Less Air Conditioning

1.

Disconnect battery ground cable and drain cooling system.

2.

Disconnect heater hoses from heater core tubes. Cap tubes to prevent leakage of coolant.

3.

Remove glove compartment door, liner and lower reinforcement.

4.

Move temperature control lever to WARM.

5.

Remove the four screws attaching heater core cover to heater assembly, then remove the cover.

6.

Working from engine compartment, loosen the two nuts attaching heater case assembly to dash panel.

7.

Push heater core tubes toward the passenger compartment to loosen heater core from heater case assembly. Working from passenger compartment,
pull heater core from heater case assembly and remove heater core through glove compartment opening.

8.

Reverse procedure to install.

Fig. 28 Heater core removal

With Air Conditioning

1.

Disconnect battery ground cable, drain cooling system and disconnect heater hoses from heater core.

2.

Working from inside vehicle, remove two screws retaining floor duct to plenum. Remove two screws retaining floor duct to instrument panel, then
remove floor duct.

3.

Remove four screws attaching heater core cover to heater case, then remove heater core cover and heater core from plenum, Fig. 28.

4.

Reverse procedure to install. 

Hose/Line HVAC > < Heater Core - Core Leak Test Procedure|Page 5550