Escort L4-116 1.9L SOHC HO (1989)
Horn Switch: Service and Repair
Fig. 3 Turn Signal, Hazard, Horn, Flash-to-pass & Dimmer Switch
MODELS LESS PASSIVE RESTRAINT SYSTEM
1.
Disconnect battery ground cable.
2.
Remove 5 shroud screws, then the lower shroud.
3.
Remove upper shroud assembly.
4.
Grasp switch lever and pull lever straight out from switch assembly, Fig. 3.
5.
Peel back foam switch cover from turn signal switch.
6.
Disconnect 2 electrical connectors.
7.
Remove 2 self tapping screws attaching switch assembly to lock cylinder housing, then disconnect switch from housing.
8.
Reverse procedure to install.
MODELS W/PASSIVE RESTRAINT SYSTEM
1.
Disarm airbag system as described under MAINTENANCE PROCEDURES/AIRBAG SYSTEM DISARMING.
2.
Disconnect battery ground cable.
3.
Remove five shroud attaching screws, then lower shroud.
4.
Remove upper shroud.
5.
Remove switch lever by grasping lever and pulling lever straight out from switch.
6.
Peel back foam switch cover from turn signal switch.
7.
Disconnect two switch electrical connectors and Airbag slip ring connector from column harness.
8.
Remove two self tapping screws attaching switch to lock cylinder housing, then disengage switch from housing.
9.
Reverse procedure to install.
10.
On models equipped with airbag, rearm airbag system as described under MAINTENANCE PROCEDURES/AIRBAG SYSTEM
DISARMING.
