Escort L4-116 1.9L SOHC HO (1989)
Input Shaft: Service and Repair
INPUT CLUSTER SHAFT BEARING
1. If damaged, remove input cluster shaft bearing using pinion bearing cone remover/installer, tool No. D79L-4821-A or equivalent and a press.
2. Reverse procedure to install.
BEARING CUPS
The input cluster shaft and mainshaft are supported at each end by roller bearings. Three cups which support the bearings are located in the
transmission case and three cups are located in the clutch housing case. The bearing cups are not pressed into the case, but are slip-fit and may be
removed and installed by hand. Shims to preload the bearings are located behind the bearing cups in the transmission case. It is necessary to keep
the preload shim with its matching cup during disassembly.
Clutch Housing Funnel
Service Shim Replacement Chart
After removal of the mainshaft bearing cup from the clutch housing, the funnel, may be removed from the bearing cup bore. The funnel directs
lubricant to a drilled hole in the center of the mainshaft where it lubricates the gears. The bearing cups should be lubricated lightly prior to
installation. Whenever the preload bearing shims are replaced, a service shim should be installed in place of the original shim.
