ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Heated Backlite Grid - Manual Updates|Page 6854 > < Heated Backlite Grid - Manual Updates|Page 6852
Page 16
background image

the timing circuit, the rocker or button is depressed to the OFF position, or the ignition is turned to the OFF position. The circuit is protected by a fuse
located in tile ruse panel and a fuse link. The operating rocker (Taurus) or buttons (Sable) are spring-loaded to return from ON or OFF to its center
(normal) position.

As soon as the switch is depressed to the ON position, it electrically connects power to energize the timer relay coil, causing the normally open relay
load contacts to close and provide power to the ON lamp and the rear window grid wires. The grid wires will continue to receive power for
approximately 10 minutes.

The control can be deactivated before automatic time out by momentarily depressing it to the OFF position or when the ignition switch is turned to the
OFF position. For individual wiring liarness applications, refer to Section 34-20.

MAJOR SERVICE OPERATIONS

Grid Wire Repair
NOTE:

A single break or any breaks that total more than 25 mm (1 inch) in one grid cannot be repaired. The rear window must be replaced.  For
breaks less than 25 mm (1 inch) long, use the following procedure:

Surface Preparation
1.

The vehicle should be brought inside and permitted to come to room temperature of 16~C (60~F) or above.

2.

Clean entire grid line repair area with Ultra Clear Spray Glass Cleaner E4AZ-19C507-AA (ESR- 

M1495-A) or equivalent, to remove all dirt, wax, grease, oil or other foreign matter. It is important that repair area be clean and dry. Mixing The bottle
of Grid Repair Compound D8AZ-19562-A (ESB-M4J58-A) or equivalent and touch-up paint must be at room temperature. Shake bottle for at least one
minute for thorough mixing. Shake frequently during use.

Continental

1988 Continental
Window, Rear-Defroster

36-86-1

36-86-1

SECTION 36-86 Window, Rear-Defroster

SUBJECT

PAGE

DESCRIPTION AND OPERATION                  

36-86-1

MAJOR SERVICE OPERATATIONS
Grid Wire Repair                             

36-86-2

Lead Wire Terminal Service                    

36-86-3

REMOVAL AND INSTALLATION
Relay Control Assembly                       

36-86-4

Switch                                     

36-86-3

SUBJECT

PAGE

REMOVAL AND INSTALLATION (Cont'd.)
Window                                   

36-86-4

TESTING
Grid Wire Test                             

36-86-5

Relay Tests                               

36-86-4

Switch Assembly                           

36-86-5

VEHICLE APPLICATION                        

36-86-1

Heated Backlite Grid - Manual Updates|Page 6854 > < Heated Backlite Grid - Manual Updates|Page 6852