Escort L4-116 1.9L VIN 9 TBI (1987)
Crankshaft Main Bearing Seal: Service and Repair
1.
Remove transaxle assembly.
2.
Remove rear cover plate, then the flywheel.
3.
Using a suitable tool, punch a hole into seal metal surface between lip and block. Screw in threaded end of suitable slide hammer, then remove
seal. Use care not to damage oil seal surface.
4.
Inspect crankshaft seal area for damage that may cause new seal to leak. If damage is present, repair or replace crankshaft as necessary.
5.
Apply a suitable lubricant to new seal, then install seal using tool No. T81P-6701-A or equivalent.
6.
Tighten bolts evenly as to allow seal to seat straight, then install flywheel and torque attaching bolts to 54-64 ft. lbs.
7.
Install rear cover plate, then the transaxle.
