ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Engine - Hard or No Start/Lacks Power|Page 3994 > < Component Locations|Page 3985
Page 1
background image

Intake Air Temperature Sensor: Customer Interest
Engine - Hard or No Start/Lacks Power

HARD OR NO START, LACKS POWER - 1.9L CFI -

Article No.

12A581 WIRE HARNESS CHAFING

87-11-16

FORD:

1987 ESCORT, EXP

LINCOLN-MERCURY: 1987 LYNX

ISSUE:

Hard start, no start, or lack of power may be caused by the wires (12A581 wire harness) for the air charge temperature sensor and fuel
injector chafing on the flange of the rocker cover and grounding out.

ACTION:

To correct this, repair and secure the damaged wires using the following service procedure.

Figure 15 - Article 87-11-16

1.

Locate wires for air charge temperature sensor and fuel injector, near throttle body at back of engine, Figure 15.

2.

If wires are damaged, repair and tape as necessary.

NOTE:

If wires are not damaged, perform normal diagnostic procedures to identify driveability concerns. However, Step 3 should be performed
to prevent future chafing of the wires.

3.

After repairing the damaged wires, install convolute tubing (D4SZ-14A099-F) on both wires, butting one end against connector and wrap both
ends with electrical tape. Check routing of wire harness (12A581), making sure it is properly seated, Figure 15.

4.

Check vehicle for proper operation.

PART NUMBER

PART NAME

CLASS

D4SZ-14A099-F

Convolute Tubing

C

OTHER APPLICABLE ARTICLES: None
WARRANTY STATUS: Reimbursable within the provisions of the Warranty and Policy Manual
OPERATION: SP871116A - Repair damaged wires and install convolute tubing
TIME:

0.6 Hr.

Engine - Hard or No Start/Lacks Power|Page 3994 > < Component Locations|Page 3985