Escort L4-116 1.9L VIN 9 TBI (1987)
The repair coating will air dry in approximately one minute and can be energized within three to five minutes. Optimum hardness and adhesion occurs
after approximately 24 hours. At that time, the repair area may be cleaned with a mild window cleaner.
Lead Wire Terminal Service
1.
Allow rear window to warm up to room temperature for one-half hour to a hour.
2.
Clean bus bar in area to be repaired using fine steel wool (3/0 to 4/0 grade).
3.
Restore area where bus bar terminal was originally attached by applying three coats of Grid Repair Compound D8AZ-19562-A (ESBM4J58-A) or
equivalent. Allow approximately ten minutes drying time between coats.
4.
Work as quickly as possible to avoid overheating glass. Tin bus bar with solder in area where terminal will be reattached.
5.
Using a heat gun or heat lamp, preheat glass in the solder area to 67~-83~C (120~-150~F), just prior to soldering terminal on.
6.
Position terminal on bus bar in area that was tinned and hold it in place with an ice pick or screwdriver.
7.
Apply soldering heat to pad of terminal until solder flows.
CAUTION: To avoid damaging bus bar, remove soldering gun or Iron as soon as the solder flows.
8.
Start the vehicle, turn heater rear window on, and leave it on for five minutes. Inspect terminal and apply Grid Repair Compound D8AZ-19562- A
(ESB-M4J58-A) or equivalent to the required area.
Tempo/Topaz - Escort/Lynx
1987 Tempo/Topaz - Escort/Lynx
36-86-6
Window, Rear-Defroster
36-86-6
