Escort L4-121 2.0L SOHC VIN P SFI (2002)
Ignition Cable: Service and Repair
REMOVAL
1. Grasp the spark plug boot firmly and with a twisting motion, disconnect the ignition wires from the spark plugs.
CAUTION: Do not pull on the spark plug wires directly, as the wire may separate from the connector inside the boot.
2. Squeeze the locking tabs and twist while pulling upward to disconnect the spark plug wires from the ignition coil and remove the ignition wires.
INSTALLATION
1. Connect the spark plug wires to the correct ignition coil terminal.
CAUTION: Correct installation of the ignition wires is critical to engine operation. If one spark plug wire is not correctly installed at either the
spark plug or the ignition coil, both spark plugs connected to the ignition coil may not fire under load.
NOTE:
^
Whenever an ignition wire is reinstalled, or a new one is installed, apply the dielectric compound to the interior surface of the ignition wire
boot.
^
Before installing the spark plug wires, inspect the spark plug wires for any visible damage; install new wires if necessary.
2. Connect the spark plug wires to the correct spark plugs.
