Escort L4-122 2.0L SOHC (1997)
8. Remove the (A) 3-4 clutch piston large seal and the (B) 3-4 clutch piston inner seal.
Assembly
CAUTION: Composition clutch plates and synthetic seals should not be cleaned in a vapor degreaser or with any type of detergent cleaner. To clean
these parts, wipe them off with a lint free cloth. New clutch plates or bands should be soaked in the specified transaxle fluid for two hours before being
assembled.
NOTE: Clutch clearances are adjusted by the selection of snap ring thickness. If the clearance is not within specification, adjust as necessary.
1. Clean the components with a suitable solvent and use compressed air to dry all parts and clean the fluid passages. Perform the following before
assembly:
-
Inspect the clutch cylinder damage or wear.
-
Inspect all clutches for damage or wear.
-
Check the clutch piston and drum seal area for burrs or damage.
2. Measure the 3-4 drive plate facing thickness.
NOTE: Measure the facing thickness in three places and calculate the average value.
-
The standard facing thickness should be 1.6 mm (0.063 inch); the minimum is 1.4 mm (0.055 inch). If not within the specification, replace the
drive plates.
3. Measure the 3-4 clutch piston spring free length. If not within the specification, replace the 3-4. clutch piston spring.
