Escort L4-122 2.0L SOHC (1997)
b.
Reinstall front attaching point of engine support cross-member with the original two (2) bolts, two (2) new Lower Bushings
(F7CZ-6A061-BA), and two (2) new Upper Bushings (F7CZ-6A061-AA) that were modified in Step A (Figure 3). Apply 2-3 drops of
threadlocker (EOAZ-19554-AA) to the bolts.
c.
Reinstall rear attaching point of engine support cross-member using new Bushings (F7CZ-6A061-BA and F7CZ-6A061-AA) and original
nuts (Figure 3). Both rear position upper bushings must be installed in "AS IS" condition (UNMODIFIED).
d.
Torque the retaining nuts and bolts to 64-89 N.m (47-65 lb-ft.).
11.
Reinstall the front attaching points of the Belly Band with the original two (2) bolts. Apply 2-3 drops of threadlocker (EOAZ-19554-AA) to the
bolts (Figure 1).
12.
Reinstall rear-attaching points of the Belly Band with original two (2) nuts (Figure 1).
13.
Torque the retaining nuts and bolts to 64-89 N-m (47-65 lb-ft.).
14.
Install the Engine Mount # 1 and # 2 retaining nuts, do not tighten at this time. (Figure 8).
15.
Lower the vehicle.
NOTE
THE ENGINE MOUNT REPLACEMENT DIRECTIVE APPLIES ONLY TO 1997-1999 MY VEHICLES BUILT PRIOR TO 01/29/1999.
NOTE
ENGINE MOUNT # 3 BRACKET REPLACEMENT DIRECTIVE APPLIES ONLY TO VEHICLES BUILT PRIOR TO 06/15/2002.
