Escort L4-122 2.0L SOHC VIN P SFI (1999)
Seat Belt: Service and Repair
Service Procedures
Post Collision Inspection
1. Before installing the new safety belt assembly, the safety belt attaching areas must be inspected for damage and distortion. If the attaching points
are damaged and distorted, the sheet metal must be reworked back to its original shape and structural integrity.
WARNING: All safety belt assemblies including retractors, buckles, front seat belt buckle support assemblies (slide bar), shoulder belt
height adjusters, if so equipped, child safety seat tether attachments, and attaching hardware should be inspected after any collision. All
belt assemblies should be replaced unless a qualified technician finds the assemblies show no damage and operate properly. Belt
assemblies not in use during a collision should also be inspected and replaced if either damage or improper operation is noted.
NOTE: Safety belt assemblies should be periodically inspected to make sure they have not become damaged and that they remain in proper
operating condition, particularly if they have been subjected to severe stress.
2. Install the new safety belt(s) using the appropriate instructions. Perform the Functional Test. See: Testing and Inspection/Component Tests and
General Diagnostics
Safety Belt Tongue Rotated on Belt
1. Fold the safety belt as indicated.
2. Pull the safety belt tongue over the fold in the safety belt.
Seat Belt With Anchor Plate Thread Damage
1. Remove the broken or stripped bolt and discard.
2. Drill out the internal threads in the safety belt anchor plate with a 10.7 mm (27/64 in) drill.
3. Rethread the anchor plate with a 1/2-13 tap (seat belt).
4. Clean out the chips.