Escort L4-122 2.0L SOHC VIN P SFI (1999)
^
Apply Urethane Metal Primer meeting Ford specification WSB-M2G234-C to any exposed metal on the pinch weld. Allow ten minutes
drying time.
^
If reusing the windshield glass, clean off all of the old Urethane Adhesive with a razor blade then with an alcohol-free glass cleaner.
INSTALLATION
1. Dry set the windshield glass.
^
Position the windshield glass in the pinch weld.
^
Align the windshield glass from the bottom center point of the glass out to the two spacers at the bottom of the pinch weld.
^
Align the gap of the windshield glass at the top and sides of the back window glass edge to the pinch weld edge.
^
Mark the windshield glass and the body when aligned as specified.
^
Remove the windshield glass from the pinch weld and clean the back window glass inside perimeter with an alcohol-free cleaner and wipe with
a clean cloth.
NOTE: Keep glass and body surfaces free of dirt, water, and oil. Do not touch coated surfaces with your hands.
2. Apply Urethane Glass Prep meeting Ford specification WSB-M5B280-C and repeat the application.
^
Apply Urethane Glass Prep to the windshield glass directly inside the blackout ceramic coating.
^
Immediately wipe off Urethane Glass Prep. Repeat Urethane Glass Prep application.
NOTE: Immediately wipe off the Urethane Glass Prep after application because it flash dries.
