ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Body and Frame > < Radio Power Boost Switch|Locations
Page 1
background image

Trailer Adapter Kit: Technical Service Bulletins
Graphic Display - False or No Warnings

WIRING RELAY - TRAILER LIGHTING SYSTEM - ALL VEHICLES EQUIPPED WITH GRAPHIC DISPLAY OR LAMP OUTAGE WARNING
SYSTEM

Article No. 88-2-6

FORD:

1980-86 MUSTANG
1980-88 THUNDERBIRD 
1981-88 ESCORT
1983-85 GRANADA 
1984-87 TEMPO 
1986-88 TAURUS

LINCOLN-MERCURY: 1980-83 MARK VI 

1980-86 CAPRI 
1980-88 COUGAR, LINCOLN TOWN CAR
1981-87 LYNX 
1982-88 CONTINENTAL 
1983-85 MONARCH 
1984-87 TOPAZ 
1984-88 MARK VII 
1986-88 SABLE

LIGHT TRUCK:

1983-88 RANGER 
1984-88 BRONCO II

ISSUE:

False warnings or no warnings indicated on the graphic display module or lamp outage warning system may be caused by a poor connection
when installing a wiring relay for the trailer lighting system.

ACTION:

When installing a trailer lighting system on any vehicle equipped with graphic display modules or lamp outage warning systems, use the
following procedure.

1.

Connect taillamp relay to the No. 14 circuit (brown wire) in the main (14401) wiring assembly.

NOTE: Electrical connections cannot be made at the rear taillamp sockets because these indicator systems require resistance

wires in the circuit and connections must be made ahead of resistance wires. The required relays may be mounted in any
convenient location where they are not susceptible to water contamination.

2.

Right and left hand stop and turn relays must be connected to the No. 5 circuit (orange/light blue wire) and the No. 9 circuit
(light green/orange wire) respectively in the main (14401) wiring assembly near turn signal switch connector.

NOTE: Indicator system will not monitor trailer lights.

OTHER APPLICABLE ARTICLES: None
WARRANTY STATUS: "INFORMATION ONLY"

Body and Frame > < Radio Power Boost Switch|Locations