Escort L4-98 1.6L SOHC VIN 5 FI (1985)
1.
Apply hot diluted solution with soft mitt.
2.
Agitate to create suds. Suds hold the acid solution in suspension and to the surface creating greater and extended activity.
3.
Allow 3 to 5 minutes dwell time.
4.
Rinse with COLD WATER.
5.
Apply # 883 per label instructions.
LIQUID NEUTRALIZER CONCENTRATE
1.
Using a mitt, thoroughly go over the entire surface with the diluted solution (50-1) of water and # 118 Liquid Neutralizer Concentrate. Then wipe
dry.
2.
If the iron particles are not totally removed after 2 washings, use one or both of the following service actions.
a.
Sand with micro fine sandpaper (1500 Grid or greater) in localized areas.
b.
Buff with very light compound and polish with wax in localized areas.
WARNING:
OUR ENVIRONMENT IS PRECIOUS - PLEASE USE PROPER DISPOSAL TECHNIQUES FOR ANY VOLATILE ORGANIC
COMPOUNDS (V.O.C.'S) OR EXCESS MATERIALS.
(B) Paint Exterior Color Peeling From Ultra Violet Light
Paint may be damaged because of ultra violet light absorption through the color coat. This damage will cause the top coat to peel to the E-coat primer.
If service is required, use the following procedure to correct the concerns.
NOTE:
READ THE ENTIRE SERVICE PROCEDURE BEFORE STARTING REPAIRS.
WARNING:
ALWAYS WEAR A NOISHA/MSHA RECOMMENDED VAPOR/PARTICULATE RESPIRATOR AND USE OTHER
RECOMMENDED SAFETY EQUIPMENT.
1.
Wash the vehicle with soap and water.
2.
Verify topcoat adhesion by applying a 2 inch wide masking tape strip on all body panels above and below the beltline on each panel.
a.
Pull the tape up quickly.
b.
Inspect the adhesive side of the tape for paint removal.
NOTE:
IF PAINT WAS REMOVED DURING THE TAPE TEST, THE ENTIRE PANEL SHOULD BE STRIPPED AND REFINISHED AS
NECESSARY.
3.
Remove all trim (mouldings, name plates, striping, etc.) from the areas which will be repainted.
NOTE:
ALL REQUIRED REPLACEMENT MOULDINGS AND STRIPES SHOULD BE ORDERED AND RECEIVED PRIOR TO REPAIRING
THE CUSTOMER'S VEHICLE.
4.
Wipe the entire vehicle with wax and grease remover.
^
BASF Product # 900 Prekleano
^
PPG Product # DX300
^
S-W Product # R7-K156
^
DuPont Product # 3919 S
^
Sikkens Product # M 600
5.
Mask off all areas on the vehicle which are not going to be painted or will be affected by overspray (engine compartment, wheels, etc.).
