Escort L4-98 1.6L SOHC VIN 5 FI (1985)
NOTE:
IF PAINT WAS REMOVED DURING TAPE TEST, THE ENTIRE CLEARCOAT AND BASECOAT SHOULD BE REMOVED FROM THE
PANEL.
3.
Wipe down the areas to be repainted with wax and grease remover.
^
BASF product # 900 PreKleano or equivalent
4.
Sand the affected surface with 150/240 grit sand paper. Remove only clearcoat and colorcoat, featheredge areas with 320 grit paper.
NOTE:
DO NOT REMOVE SPRAY PRIMER OR E-COAT.
5.
Blow off the area to remove loose dust or debris.
6.
Wipe the sanded surface with wax or grease remover.
^
BASF product # 901 Prekleano or equivalent
7.
Tack off area.
8.
Mix and apply one coat of epoxy primer for adhesion and let dry per manufacturer's label instruction (20 - 30 minutes).
^
BASF product # DE 15, PA16, PR80 or equivalent
NOTE:
DO NOT SAND THE NEWLY PRIMED AREAS.
9.
Mix and apply two coats of the appropriate colored primer surface sealer.
^
BASF product # DP 21, Solo Color 1:1, then 2 parts of mixture 1 part DH 60, 30% PR80 or equivalent.
10.
Mix and apply 2 coats or until hiding of basecoat per manufacturer's label instructions. Apply first coat to repair area only. Apply second coat over
entire area. Allow a minimum of 15 minutes flash time before applying the clearcoat.
^
BASF # Diamont Basecoat Color and Diamont Reducer 1:1 or equivalent.
11.
Mix and apply 2 coats of urethane clearcoat per manufacturer's label instructions.
^
BASF product # DC90 Diamond Clear, LH50 Diamond Hardener 2:1 or equivalent.
12.
Polish if necessary.
13.
Clean and detail the vehicle and return it to the customer.
WARRANTY STATUS: INFORMATION ONLY
OASIS CODES: 106000
Technical Service Bulletin # 9384
Date: 930414
Exterior Clearcoat - Cracking/Eroding/Peeling Off
Article No.
93-8-4
April 14, 1993
PAINT - EXTERIOR CLEARCOAT "MICROCHECKING", HAZING OR PEELING
FORD:
1983-93 THUNDERBIRD
1984-93 TEMPO
1985-93 ESCORT
1986 LTD
