ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

All Other Service Bulletins for Ignition Control Module: > < TFI/MAP Connectors - No Start Condition
Page 2
background image

Figure 12 - TFI Module Connector

MAP Sensor Connector

1.

Check to make sure that the water seal is completely around the outside of the mating connector (see Figure 12).

2.

If the water seal is folded under in anyway, replace the connector.

NOTE:

When the water seal is folded under it takes on a permanent set and proper sealing is not achieved by repositioning the old connector.

If both of the above connectors check out o.k., perform "No Start" diagnostic procedures.

PART NUMBER

PART NAME

CLASS

E5ZZ-12A209-A

TFI Connector

C

E5DZ-12A209-A

MAP Connector

C

OTHER APPLICABLE ARTICLES: None
WARRANTY STATUS: Reimbursable within the provisions of the Warranty and Policy Manual.
OPERATION: SP12209A85
TIME:

0.6 Hr. DLR. CODING: Basic Part No. 12A209 or 9J443 -
Code:

N2

All Other Service Bulletins for Ignition Control Module: > < TFI/MAP Connectors - No Start Condition