Escort L4-98 1.6L SOHC VIN 5 FI (1985)
1.
Position lock cylinder housing on upper steering column flange bracket. Place ignition switch in start position to locate actuator interlock through
clearance hole in outer tube. Install lock cylinder housing bolts and torque to 12---20 ft. lbs.
2.
Install steering shaft assembly into steering column tube. Use care not to damage lower bearing.
3.
Install upper casting assembly with tilt spring in position, over end of shaft and down onto lock cylinder ears making certain lock lever is latched
into top tilt position.
4.
Install tilt pivot pins through lower casting holes and into upper casting using a suitable C-clamp. Pivot pins must be flush with outer casting
surface.
5.
Install C-clip ring on upper shaft groove above bearing.
6.
Install upper bearing plate and conical spring. Press conical spring onto upper shaft until spring snaps into upper groove.
7.
Install turn signal switch, then lower column clamp, ensuring locating nib is in hole in shaft. Install steering column and steering wheel.
