ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Keyless Entry Transmitter|Mexican|Page 7023 > < Keyless Entry Module|Specifications|Page 7018
Page 1
background image

Keyless Entry Transmitter: Service and Repair
Mexican

NOTE:

^

A maximum of four keyless entry remote transmitters can be programmed for each Remote Anti-theft Personality (RAP) module. Programming
must be done at the same time for all the transmitters.

^

Before entering the program mode, first verify that the battery is fully charged and that the anti-theft system is not armed or triggered (if equipped).

^

Be aware that when entering the program mode, other transmitters pressed within 30 meters (100 ft) of the vehicle may be programmed to the
vehicle.

1. Turn the ignition switch from OFF to ON eight times within ten seconds, ending with ON, or turn the ignition switch from OFF to START four

times within 10 seconds, ending with ON.

2. Press any button on the keyless entry remote transmitter.

NOTE:  If the RAP module successfully entered the program mode, it will lock and then unlock all doors. (Anti-Theft system, it will chirp the
horn.)

3. To program additional transmitters, repeat step 2.

NOTE:  The door locks will lock and then unlock to acknowledge that the keyless entry remote transmitter has successfully been programmed.
(Anti-theft system, it will chirp the horn.)

4. When finished programming all transmitters, turn the ignition switch to OFF.

NOTE:  The door locks will lock and then unlock one last time to indicate the new keyless entry remote transmitters have been programmed and
the program mode has been exited. (Anti-theft system, it will chirp the horn one last time.)

Keyless Entry Transmitter|Mexican|Page 7023 > < Keyless Entry Module|Specifications|Page 7018