Escort ZX2 L4-2.0L DOHC VIN 3 (2000)
6. CAUTION: Tension the timing belt, working counterclockwise.
Using the hex key, rotate the adjusting washer counterclockwise until the notch in the pointer is centered over the index line on the locating tab (the
pointer will move clockwise during adjustment).
7. While holding the adjusting washer in position, tighten the bolt.
8. CAUTION The camshaft must be held stationary at the hexagons with locking pliers. Do not use the alignment tool to hold the camshaft in
position or damage to the camshaft may occur.
Tighten the bolt on the intake camshaft sprocket.
Tighten the bolt on the exhaust camshaft sprocket in three stages.
-
Stage 1: Tighten the bolt to 50 Nm (36 lb-ft).
-
Stage 2: Remove the TDC peg and the camshaft alignment timing tool.
-
Stage 3: Tighten the bolt to 115-125 Nm (85-92 lb-ft).
10. NOTE: Install a new oil plug seal.
