Escort ZX2 L4-2.0L DOHC VIN 3 (2000)
Screw in the new oil plug on the variable camshaft timing assembly.
11. NOTE: turn the engine two turns in the normal direction of rotation by the crankshaft.
Check the valve timing by inserting the special tools and correct the alignment as necessary.
-
Screw in special tool 303-574 and make sure that the crankshaft is resting against the special tool.
-
Insert special tool 303-465 into the camshafts. If necessary loosen the timing pulleys and correct the camshaft alignment.
-
Remove the special tools.
12. Install the stud bolt.
13. Install the catalytic converter. See: Engine, Cooling and Exhaust/Exhaust System/Catalytic Converter
14. Install the timing belt covers. For additional information, refer to Timing Drive Components - Timing Belt Covers in this section.
15. Install the valve cover. See: Engine, Cooling and Exhaust/Engine/Cylinder Head Assembly/Valve Cover
15. Install the valve cover. For additional information, refer to Valve cover in this section.
16. Connect the heated oxygen sensor (HO2S) electrical connector.
17. Install the spark plugs.
18. NOTE: Whenever an ignition wire is reinstalled, or a new wire is installed, apply dielectric compound to the interior surface of the spark plug
wire boot.
