Escort ZX2 L4-2.0L DOHC VIN 3 (2000)
3. Install the snap ring on the outboard side of the driveshaft.
4. Install a new driveshaft bearing retainer circlip.
5. Use a soft-face hammer to install the front wheel driveshaft joint by gently tapping it onto the driveshaft.
6. Remove any excess grease on the mating surfaces and slide the front wheel driveshaft joint boot forward onto the driveshaft joint.
7. Remove any excess air trapped in the front wheel driveshaft joint boot using a cloth covered screwdriver after adjusting the front wheel driveshaft
joint boot spacing.
