Excursion 2WD V10-6.8L VIN Z CNG (2003)
7. Disconnect the auxiliary evaporator inlet line fitting.
8. Remove and discard the auxiliary evaporator inlet line.
INSTALLATION
1. Install the rear auxiliary evaporator inlet line and connect it to the auxiliary evaporator inlet line.
NOTE: Lubricate the O-ring seals with PAG Refrigerant Compressor Oil (R-134a Systems) F7AZ-19589-DA (Motorcraft YN-12-C) or
equivalent meeting Ford specification WSH-M1C231-B.
2. Snap the rear auxiliary evaporator inlet line into the line brackets.
3. Install the front auxiliary evaporator inlet line through the wheel well and connect the evaporator inlet line.
NOTE: Lubricate the O-ring seals with PAG Refrigerant Compressor Oil (R-134a Systems) F7AZ-19589-DA (Motorcraft YN-12-C) or
equivalent meeting Ford specification WSH-M1C231-B.
4. Snap the rear auxiliary evaporator inlet line into the brackets.
