Excursion 2WD V10-6.8L VIN Z CNG (2003)
1. Install the safety belt retractor.
1
Position the safety belt retractor under the seat frame.
2
Align the tab to the slot in the floor.
3
Install the bolt.
2. Install the safety belt bracket cover.
3. Adjust the seat to the full forward and rearward positions a few times to ensure safety belt and buckle accessibility.
4. Check the restraint system for correct operation.
Second and Third Row, Outboard
Safety Belt Bolt Bit
SPECIAL TOOL(S)
REMOVAL
NOTE: New safety belt buckles, height adjusters, center adjust tongues and belts and retractors can be installed separately. However, if a safety belt
assembly was in use during a collision, a new belt and retractor must be installed as well as the center adjust tongue and belt and buckle assembly or the
center adjust tongue and the cable and buckle assembly. When installing new safety belts and buckles, height adjusters, safety cables and buckles, center
adjust tongues and belt and retractors, use only the parts specified in the Ford Master Parts Catalogs for the make and model of the vehicle being
repaired. Safety belt assemblies must not be interchanged between vehicle models.
Both sides
1. Adjust the second row seat to its most forward position.
2. Remove the third row seat.
