Excursion 2WD V10-6.8L VIN Z CNG (2003)
16. Remove the third row shoulder safety belt guide.
1
Peel the shoulder safety belt guide cover down to access the bolt.
2
Using the special tool 501-010 (T77L-2100-A), remove the bolt.
3
Remove the shoulder safety belt guide.
CAUTION: If the safety belt retractor is to be reused, do not allow the safety belt to be retracted all the way into the retractor. Doing so may
cause the retractor to lock and not release the safety belt.
NOTE: Inspect the shoulder safety belt guide and cover for damage. If the shoulder safety belt guide or cover is damaged or cover does not
remain closed, install a new shoulder safety belt guide.
17. Pull to release the retaining clips and remove the C-pillar trim panel.
18. Remove the pin-type retainers out of the quarter trim panel.
NOTE: Passenger side is shown, driver side is similar.
