Excursion 2WD V10-6.8L VIN Z CNG (2003)
6. Disconnect the tie rod end.
1
Remove and discard the cotter pin.
2
Remove the castellated nut.
3
Using the Pitman Arm Puller, remove the tie rod end.
7. Remove the pinch bolt.
8. Remove the camber adjuster.
9. CAUTION: To prevent damage to the ball joint seal and the ball joint socket, do not use a pickle fork-type remover to loosen the ball joints.
Remove the front wheel spindle.
1
Remove and discard the cotter pin.
2
Loosen, but do not remove, the castellated nut.
3
Strike the lower end of the front axle to loosen the ball joint.
4
Remove the castellated nut and the front wheel spindle.
Installation