Excursion 2WD V10-6.8L VIN Z CNG (2003)
Transmission Mount: Service and Repair
4R100 Automatic Transmission
Transmission Insulator and Retainer
Removal
NOTE: 4x2 shown, 4x4 similar.
1. Raise the vehicle on a hoist.
2. Remove the nuts.
3. Install a suitable high-lift transmission jack.
4. CAUTION: Be sure not to raise the back of the transmission too high. If it makes contact with the underbody, damage to the TSS and OSS
sensors will occur.
Remove the rear transmission mount.
1
Raise the transmission up off the rear crossmember support.
2
Remove the bolts.
3
Remove the rear transmission mount.
Installation
1. CAUTION: Be sure not to raise the back of the transmission too high. If it makes contact with the underbody, damage to the TSS and OSS
sensors will occur.
Install the rear transmission mount.
1
Raise the transmission up.
2
Install the rear transmission mount.
3
Install the bolts.
