Excursion 2WD V8-5.4L SOHC VIN L (2000)
Alarm System Transponder: Service and Repair
REMOVAL
1. Disconnect the battery ground cable. Refer to Battery.
2. Remove the ignition switch lock cylinder.
1
Insert the ignition key and turn to the RUN position.
2
Using a 1/8-inch drift through the access hole, press the ignition switch lock cylinder release pin while pulling out the ignition switch lock
cylinder.
3. Twist the tilt wheel handle and shank to remove.
4. Remove the three upper and lower steering column shroud retaining screws, and remove the upper and lower shrouds.
5. Remove the lower instrument panel steering column opening cover.
