Excursion 2WD V8-5.4L SOHC VIN L (2000)
BODY SUPPORT-REAR, CREW CAB, UPPER
Removal
1. CAUTION: When removing upper body insulators, all other body mount support bolts have to be loose before raising the vehicle cab to
prevent permanent structural damage from happening to the vehicle cab.
Remove the rear lower body insulation.
2. Remove the opposite side rear body insulator bolt.
3. Remove and discard the left and right middle body insulator bolts.
4. Remove and discard the left and right front body insulator bolts.
5. Raise the vehicle cab enough to allow removal of the insulator.
6. Remove the insulator.
Installation
NOTE: Do not reuse body support mounting fasteners. New fasteners must be installed for each fastener that has been removed or loosened.
1. NOTE: No lubricants of any kind are to be used during body insulator installation.
Follow the removal procedure in reverse order
Body Support - Number 2 Lower, Excursion
BODY SUPPORT-NUMBER 2 LOWER, EXCURSION
Removal and Installation
NOTE:
-
Do not reuse body support mounting fasteners. New fasteners must be installed for each fastener that has been removed or loosened.
-
The removal and installation of the LH body mount is shown, removal and installation of the RH body mount is similar.
1. Remove the cowl side trim panel.
2. Pull the carpet back.
