Excursion 2WD V8-5.4L SOHC VIN L (2000)
2
Slide the core wire end out of the speed control servo pulley.
INSTALLATION
1. Insert the speed control cable slug into the speed control servo pulley slot.
1
Gently compress the speed control servo spring.
2
Insert the speed control cable slug into the speed control servo pulley slot.
2. Release the compressed spring while aligning the speed control actuator cable cap tabs with the slots in the speed control servo housing.
CAUTION: Make sure the rubber seal is fully seated onto the speed control actuator cable cap.
NOTE: Incorrect wrapping of the speed control actuator cable around the speed control servo pulley may result in a high idle condition.
3. Rotate the speed control actuator cable cap until the locking arm engages.
