Excursion 2WD V8-5.4L SOHC VIN L (2000)
Leak Detection Valve: Service and Repair
REMOVAL
1. Disconnect the canister vent solenoid electrical connector.
2. Remove the canister vent solenoid from the evaporative emission (EVAP) canister.
NOTE: A twisting and pulling motion is necessary to remove the canister vent solenoid.
INSTALLATION
1. To install, reverse the removal procedure.
^
Carry out the evaporative emissions canister leak test. For additional information, refer to Evaporative Emission System Leak Test. See:
Testing and Inspection/Component Tests and General Diagnostics/Evaporative Emission System Leak Test
^
Carry out the evaporative emission repair verification drive cycle. For additional information, refer to Evaporative Emission Repair
Verification Drive Cycle. See: Service and Repair
NOTE:
^
Inspect and install new O-ring seals as necessary.
^
Lubricate all O-ring seals with MERPOL(R) O-ring Seal Lubricant or equivalent meeting Ford specification ESE-M99B144-B.
