Excursion 2WD V8-5.4L SOHC VIN L (2000)
6. Remove the bearing and the gear.
-
Thoroughly clean all drill shavings from the steering column and inspect it for damage.
Installation
Note: The narrow section of the keyhole in the lock gear must be in the 1 o'clock position.
1. Install the steering column lock gear and bearing.
-
Use Ignition Lock Grease F0AZ-19584-A or equivalent meeting Ford specification ESA-M1C232-A to coat the steering column lock gear and
the steering column lock housing bearing.
-
The narrow section of the keyhole must be in the 1 o'clock position, with the tab inboard at the 3 o'clock position and rotate it
counterclockwise.
2. Install the bearing retainer firmly to engage the four retention tabs into the lock housing.
3. Install the steering wheel.
4. Install the ignition switch lock cylinder.
-
Verify ignition switch lock cylinder operation.
